Outdoor 2Pcs Solar Wall Light Light Sensor Body Induction Lamp with 5M Cable


Free Shipping

  • Easy use
  • Energy saving
  • Safe and durable
  • Body induction
  • Split-type design
  • Over-charging protection
  • Over-discharging protection

Lamp Shell Material PC
Solar Panel 3W/6V
LED Bead 34pcs
LED Bead Model 2835
Lumen 350LM
Battery Capacity 1500mAh x2
Detectable Area 10 Meters,120℃
Lighting Angle 150-160℃

Package Includes
  • 2 x Solar Lights
  • 1 x Solar Panel
  • 1 x 5M Cable

Extra Info

1. Installation Method of Solar Outdoor Step Light:Install the solar panel in a place with sufficient sunlight(such as house roof, outside window, outside wall, outdoor), let maximum area of the solar panel face sunlight’s direction; Fix up the solar panel with screws
2. Install the wall lamp in the place needing lighting, connect the red waterproof connector to the connector of the solar panel
3. Lengthen with more cables if the connected cable is not long enough;
4. To test the outdoor solar lamp being charged or not, pls light up the lamp at first, then connect to the solar panel, if the step lamp lights off,that means it is being charged.(Note: the solar panel should be shined by light when testing)

Mode Conversion:
1. The mode conversion and the switch of the solar wall lamp is the same button( Noted as ”ON/OFF” ;mode conv.). The button
has four mode conv.. Press the First time is Mode 1, Second time is Mode 2, Third time is Mode 3, Fourth time is Mode 4(Light off)
2. You can set the mode you need before you fix and install the lamp. The operation procedure of each mode is as below:
(Note: No matter which mode is being used, the lamp lights up only after night falls)

1.Mode 1: Low-light level (0.5W/50LM)without human pass, turn to high-light level (2.5W/250LM) when human pass or stay

2.Mode 2: The Lamp lights up when human pass or stay, lights off when human go out of the detectable area.(2.5W/250LM)

3.Mode 3: Continuous lighting. 1.5W/150LM; Working Time: about 8-10 hrs

4.Mode 4: the lamp lights off